Rear end collisions are the # 1 common cause of accidents.
Here is an inexpensive way ($19.98) to draw attention to yourself when you brake. The 3rd Brake Light Flasher is a micro-chip that will make your brake lights, top box lights or non flashing LEDs such as Hyperlite flash in one of 36 modes. I installed mine on my ST-1300 and FJR-1300 in less than 20 min each. You can also mount one of these on your car, truck, golf cart or snow mobile to draw attention to yourself.
Alert Those Behind You When Slowing Or Stopping In Traffic!!!
36 Different Flashing Modes !!!
For Cars, Motorcycles, Scooters, Golf cats, Bicycles and Mopeds.
This May Be The Most Important Safety Device You Ever Add To Your Ride!!!
It May Prevent You From Being Rear-Ended & It May Even Save Your Life!
36 Mode of operation ( 2,3,4 and 6 flashes. From STROBE to SLOW).
Works on LED and standard incandescent bulbs .
Unique Re-Activation delay with selection of 0, 20 or 40 seconds period to minize annoyance of constantly blinking lights in heavy traffic.
Temporary flashing light OFF mode.
Easy 5min install. Only 3 wires to connect, only 1 wire to cut.
Small water-proof package (.1/2" x 1/2" x 1/16") / (14mm x 14mm x 5mm).
Microprocessor based for reliability and accuracy of operation. Totally silent no relay clicking sounds.
Legal in all 50 states.
3rd Brake light flasher allows creating brake flashing effect from third brake light to catch the attention of drivers behind. The flasher module is a microprocessor based circuit specifically designed for third brake light operations and packaged in a very tiny package so it can fit behind any third brake light assembly. It works on both LED and incandescent bulbs (4amps max).
See demonstration below (due to the video format conversion some flasher modes do not look consistent in YouTube video, but they are in the real life to the human eye)
Connecting brake light flasher:
Adjusting flashing mode: